triumphs
[Top] [All Lists]

Re: after changing bearings and such (TR3A)

To: tr3driver@comcast.net, triumphs@autox.team.net
Subject: Re: after changing bearings and such (TR3A)
Date: Tue, 24 Aug 2004 19:03:35 EDT
In a message dated 08/23/2004 8:52:46 PM Eastern Daylight Time, 
tr3driver@comcast.net writes:

> >Oil pressure;
> >at start - 70 psi
> >3K rpm (at speed/at temperature-185F) - 40 (+/-10) psi
> >185F idle - 1.2K rpm (20 miles or more) 20 psi
> >185F idle -  <1.0K rpm 10 psi
> >
> >I thought I'd have more pressure at idle. Any thoughts?
> 
> Remove, clean and inspect your oil pressure relief valve.
> >>>> Done, before lower end
> Other possibilities :
> 
> There have been reports of defective new oil pumps.
> >>>> Soooo ... presure above is abbie normal? Should be higher?
> Worn cam bearings
> >>>> Possibility, haven't done anything there.
> External oil feed to rockers
> >>>> Don't recall this, I'll have to do some research. Can't even think 
> where this is located. What should I be looking for.
> Oil contamination by fuel
> >>>> Nothing evident. Plugs are brown. No indication of rich
> and probably more that haven't occurred to me yet.
> I've now put 200 miles on the repair. At speed (3K rpm), 100 mile round trip. 
Pressure is as above.

Ed (TR3A) 

> Randall

Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8




<Prev in Thread] Current Thread [Next in Thread>