Subject: | RE: Starter handle for TR3A |
---|---|
From: | "Randall Young" <Ryoung@navcomtech.com> |
Date: | Mon, 7 Jun 2004 11:02:53 -0700 |
Cc: | <triumphs@autox.team.net> |
> I had the same problem. As it turned out the engine mounts just needed > alignment. I bought some big flat washers and cut slots (just so I > wouldn't have to lift the engine so far to to fit the washers) and shimmed > until I got alignment. FWIW, the factory used shims for that purpose too ... P/N 109582. They already have slots. $2.25/each at TRF ... flat washers are certainly cheaper but the shims are 'correct'. Randall |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | RE: Starter handle for TR3A, Unknown |
---|---|
Next by Date: | Re: Starter handle for TR3A, Unknown |
Previous by Thread: | RE: Starter handle for TR3A, Unknown |
Next by Thread: | Re: Starter handle for TR3A, Unknown |
Indexes: | [Date] [Thread] [Top] [All Lists] |