Message text written by INTERNET:MotoPsyche@aol.com
>What are some effective ways to seal around the mating surfaces of the
gearbox tunnel, short of pumping in silicone sealant? I have a metal
gearbox tunnel
that was only held in place by three bolts. I've now got all the captive
nuts
cleaned out and should be able to get bolts in almost all the holes, but I
can
see that it's not water or oil tight...yet.
<
There is a gasket set for that mating surface. It consists of molded
pieces of foam rubber. You can the right parts or you can approximate it
with weatherstripping available at the local hardware store.
Dave
|