Re: re: ID-ing a part for a 1974 TR6

triumphs

Re: re: ID-ing a part for a 1974 TR6

To:	JVasko10@aol.com
Subject:	Re: re: ID-ing a part for a 1974 TR6
From:	CarlSereda@aol.com
Date:	Tue, 20 Jan 2004 23:41:03 EST
Cc:	triumphs@autox.team.net

Could be the 'reinforcement plates' for the seatbelt anchors.. check for 
clues on the sides of the driveshaft tunnel.
Carl
'63 TR4 since '74

>> I would like help in identifying a part for a 1974 Triumph TR6.  The 
>> part is a metal plate 4"x2" about 1/8th inch thick.  It has a 3/8th inch 
>> hole in the center and one side has a raised circle around the hole about 
1 
>> inch in diameter and the other side is indented.  There are 2 of these 
parts.

[More with this subject...]

<Prev in Thread]	Current Thread	[Next in Thread>
Re: ID-ing a part for a 1974 TR6, Herald948 Re: ID-ing a part for a 1974 TR6, Darrell Walker Re: re: ID-ing a part for a 1974 TR6, CarlSereda <= RE: ID-ing a part for a 1974 TR6, Jeff Tedder

Previous by Date:	RE: Ebay Stag, Mark Gendron
Next by Date:	RE: ID-ing a part for a 1974 TR6, Jeff Tedder
Previous by Thread:	Re: ID-ing a part for a 1974 TR6, Darrell Walker
Next by Thread:	RE: ID-ing a part for a 1974 TR6, Jeff Tedder
Indexes:	[Date] [Thread] [Top] [All Lists]