Hello Everyone,
Got a question, maybe requesting more of an opinion than anything else..
I am re-skining my doors and just finished the passenger side. I noticed
that the door gap is all over the place. It ranges from 1/8" to almost 1/4".
I am planning on running a MIG bead down the edge of the door to "adjust"
the gap. I don't want to get to too small as the door may not open without
binding on the front fender.
I suppose I could set it at the smaller gap and leave it at that.. Hmmm..
Maybe I just answered my own question!
Any suggestions would be greatly appreciated!
Thanks,
Dave
Dave Connitt
Cincinnati, OH
'65 TR4A
web page http://home.fuse.net/davestr4a
|