I think the $$ quoted is realistic
Paul Tegler
ptegler@cablespeed.com
www.teglerizer.com
----- Original Message -----
From: "Ronnie Babbitt" <rbtr3a@cox.net>
To: "Triumphs" <triumphs@autox.team.net>
Sent: Wednesday, November 05, 2003 4:43 PM
Subject: Better News
> Well I dropped off the engine components to the machine shop, I asked
> Steve the owner, to check for me my measurements in each of the cylinder
> bores, and he uses a three point bore gauge. After checking each bore
> (wish I had recorded his measurements) he informed me that this engine
> had very little wear and that Standard rings is what was needed for the
> pistons.
> He also looked at and measured the crank journals as well. There again
> all that is need is Standard bearings mains and rod.
>
> His services will include the following for $265.00
> Who does this price sound?..
|