> It is correct. The figure 8 gasket is under the liner, not on top. When
> you first install the liner, it does stand proud, but tightening down the
> head compresses the figure 8 gasket and make the whole block top
> level.
Bill, I disagree with that last statement. When you remove the head, the
liners should rise back to the published position, with the top proud of the
block by a few thousandths. If they don't, they should be removed and the
fig 8 gaskets replaced.
Randall
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|