> It seems that the bolt from the generator mounting bracket had sheared off,
> causing too much travel in the mounting arm. All that remains is the stud,
> as
> the head is gone. Only about 1 thread's worth protrudes from the front of
> the
> block.
If you have the room to get at it I like to use a cold chisel for this
kind of removal. Find an "ear" on the remaining bolt surface. Then set
your chisel so you can drive the bolt in a counter clockwise direction.
Repeat this process until you can turn the bolt by hand.
Regards,
Tom
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|