> I have secured from Moss the screw and metal washer shown as
> appropriate for the screw-in coil application, and I now have a
> new set of Magnecor
> wires to install. What are the next steps to properly connect
> this to the coil?
Strip about 1/4" of the insulation from the end of the wire, then slip the
nut over the wire and then the metal washer. Fold the wire down against the
washer, and solder it in place. (Let us know if the Magnecor uses a
solderable alloy.) Trim away any wire that hangs over the edge of the
washer.
Randall
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|