Used to be one though not on Triumphs: First, shoot it with CRC or PB Blaster
both are better penetrants than the old WD. NFI. Then I would try either a long
stroke air hammer with a blunt tip or a hot wrench. Around here shop labor runs
$65 to $130 per hour so it doesnt take long to buy those parts with labor.(i.e.
If I spend two hours @ $100 per to save you $75 on parts I haven't done you any
favors) Alex
--
__________________________________________________________
Meet Singles
http://corp.mail.com/lavalife
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|