On the front of the w/p is a "C" clip holding the bearings in place, remove
this clip, turn your w/p over with the impellar facing up and place in a
vise, using a good size punch so as not to distort the shaft, drive the
shaft out the front of the housing, very easy takes about 30 seconds, if you
have a press use a large bolt to rest on the shaft and then press it out.,
reinstalling, place water thrower rubber bush on shaft, place the lower
interior "c" clip on the shaft then the abutment washer, 1 bearing facing
up, spacer, 2nd bearing facing inward, load the inside space of the 2
bearings (facing each other) with grease and press into housing, reinstall
the outter "C" clip, insert new rear bushing/seal in impellar turn the W/P
over and press the impellar onto shaft, you want .085 clearence between
impellar and housing. "FT"
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|