> I went to pick up my rebuilt transmission (exchanging my old one), and
> discovered that I apparently had the transmission from an early 4
> or even a
> 3A.
Not likely it's from a 3A, unless it had no synchro-mesh on 1st gear.
> This was determined because the old transmission had a bolt to retain
> the cross-shaft, apparently later 4s and all 4As didn't have
> this. I did at
> least seem to have the correct front cover installed. Anyway,
> does anything
> hold be cross shaft in place on a 4A?
Once it's engaged with the TOB sleeve, the pins bearing on the sleeve hold
it in place.
> Can I used the old cross
> shaft, just
> allowing it to float?
Yes.
Randall
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|