If you a re talking about installing the inner and outer seals on the door
for the side glass ... I made mine from a stiff piece of 1/8" aluminum
sheet. Bent the bottom with a 1/2" lip, the top 2" for a handle to pull
with. Stuck it in a vise and hammered it over. Ends up sorta "C" shaped 8-10
inches high.
Use a bit of double sided tape or some duct tape rolled into a small loop on
the bottom to keep the clip from falling off as you position it for the
"tug".
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|