TeriAnn has a great web page to aid in identifying early TR heads:
http://www.cruzers.com/~twakeman/TR/FAQ_heads.htm
The head thickness figure listed there is 3.330" for an unshaved
"high-port" head; measure yours and subtract from 3.330" to see how
much may have been removed in the past.
Dan
At 20:54 -0500 03/02/02, ebk wrote:
>Hi List!
> Thanks to thoes who answered my 'Baking the Head' question. In
>summary, it was advised to 'wash' the head down after reciving it back
>from the shop. Thanks for the follow-through tip!
> I've been following the thread on the TR6 head about determing size
>when new from the factory. Well I'm going my TR4/A head & would like to
>know where one obtaines that info.? I ckecked in my Bently's & did NOT
>see it If any of you have this info. then would you PLEAS sent it along.
> As always, if any of you wish to contact me by my personal E-mail,
>then feel free to do so, too.
>-Cosmo Kramer
--
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Dan Buettner mailto:danb@thelittlemacshop.com
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|