-----Original Message-----
From: Paige, Dean
Sent: Tuesday, December 11, 2001 10:30 AM
To: 'Brian Sanborn'; triumphs@autox.team.net
Subject: RE: Turn Signal Replacement
Better yet take the tube off of the steering column. Screw at the top IIRC
and the lower end pressed into the dash panel- pull out. Then replace the
wiring and put the tube back on over it.
-----Original Message-----
From: Brian Sanborn [mailto:sanborn@net1plus.com]
Sent: Tuesday, December 11, 2001 7:45 AM
To: triumphs@autox.team.net
Subject: RE: Turn Signal Replacement
>===== Original Message From Brian Sanborn <sanborn@net1plus.com> =====
Charlie,
I did this with the wires on my TR4 and adding the OD switch.
Find a small flexible shaft... piano wire, RC airplane control rods,
hardware
store item. Run the flexible rod up the conduit from under the dash and out
the opening for the switch. Then tape the wires to the shaft with
electrical
tape. Spray on a little soapy water solution if it is real tight. Then
pull
the rod back out from under the dash and your done. You may want to stagger
the three connectors to keep the package as slim as possible.
Brian Sanborn
62 TR4 CT16260L(O) - Groton, MA
My TR4 Restoration Web Site
http://www.net1plus.com/users/sanborn
E-Mail: sanborn@net1plus.com
/
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|