> Well she's running a little slow & sluggish, no pep, bad acceleration,
check
> the plugs, all look clean burning, wires all firing, timing right on, just
> last week I hooked up a fuel pressure gauge and set the regulator for 2
1/2
> lbs., today checked it again, down to 1 lb., no wonder I have no power,
this
> regulator has 2 locking nuts and a screw adjustment, they all seemed
tight,
> how could it drop from 2 1/2 down to 1 on its own, any ideas so this does
> not happen anymore. Thanks "FT"
>
Fred-
Can't recall what you're working on, but Heralds run 1 to 2 1/2 lbs. by
spec. The way to increase or decrease the pressure is usually by putting a
thinker or thinner gasket in. (Thicker, decrease, thinner- increase) Have
you replaced your gasket recently- might be too thick if you did.
Check your oil for a fuel smell- you may have ruptured the diaphragm and
that is causing the loss of pressure.
Good luck with it,
Scott
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
|