Rick,
I did these on a TR6. I used TRF parts.
The easy way is: first remove your engine. Then remove the
pedal box and throttle shaft.
If you want to do it the hard way, I think you could work from
inside the footwells. Heat the bushings in hot water to soften them.
Then, cut them in half accross their diameter and that should make an
impossible job merely difficult.
Good luck.
Regards,
Rick Barnard
'73 TR6 restored - CF2570U
'71 TR6 donor car - CC63322L
///
/// triumphs@autox.team.net mailing list
///
|