Message text written by Bill Pugh
>Trying to bleed the clutch slave cylinder in Casper (57 TR3), can
only get a one way flow, ie: I can pump fluif from the slave to the
master but cannot get fluif to flow from master to slave, even with
the MityVac...tiz a Puzzlement, makes absolutely no sense, cleaned
out resivoir, blew out lines..still no master to slave flow.
<
Bill,
How old is the flex line. If it is not fairly new you may have a pending
line failure. The rubber lining inside may be swelling, flaking and acting
as a check valve with the relatively low pressures encountered with the
mighty vac but the higher pressures with the air gun are able to overcome
the obstructions. So, check the flex line.
Dave (BTDT)
///
/// triumphs@autox.team.net mailing list
///
|