Re: TR2 crankshaft bearings, cylinder sleeves, etc. (long)

["Irv Korey" <emanteno@attglobal.net>]

----- Original Message -----
From: Randall Young <ryoung@NAVCOMTECH.COM>

> BTW, you can make sleeve retainers by piling up 1/2" drive sockets on the
head studs,
> until they are tall enough to clamp in place with a head nut.

Or you can cut lengths of thinwall electrical conduit to suitable lengths to
use as spacers, and put some big washers below the conduit and above, then
use the head nuts on the studs to lock the whole thing down. Cuts down on
your need for a big socket set. ;-)

Irv Korey
74 TR6 CF22767U with A type o/d since 1983
TR4 VSCDA Group 2 #58 now improved to mid pack
Highland Park, IL

///
///  triumphs@autox.team.net mailing list
///