To: | <triumphs@autox.team.net>, "David Brady" <dmb@cisco.com> |
---|---|
Subject: | Re: [TR250] Nylatron Susp Bushings |
From: | "levilevi" <levilevi@home.com> |
Date: | Sat, 20 Jan 2001 23:47:43 -0700 |
References: | <3A6A79CA.4060604@cisco.com> |
David, Just dab some grease (I use blue marine grease intended for boat trailer wheel bearings) around the bushings as much as possible and let gravity take over. The DPO didn't grease the bushings on my TR6 and I did this. Lucky for me it took care of the squeaks. It's worth a try cause it's way easier than taking them all apart. Bud Rolofson [This message delayed, as it needed manual intervention by the list administrator. mjb.] /// /// triumphs@autox.team.net mailing list /// |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Clutch shaft removal, Michael Ferguson |
---|---|
Next by Date: | Re: Handbrake Question, Scott A. Roberts |
Previous by Thread: | [TR250] Nylatron Susp Bushings, David Brady |
Next by Thread: | Re: [TR250] Nylatron Susp Bushings, Alan |
Indexes: | [Date] [Thread] [Top] [All Lists] |