Re: Powder coating question

["Fred Thomas" <vafred@erols.com>]

Barry, buff the polished area to the bright finish you desire, then clean
the entire wheel with lacquer thinner making sure you have no contaminents
of any kind on the wheel, (preheat @300 for 15 does good), tape off the
bright area, spray and cure the gold (for 20 min.after flow out), remove the
tape and again clean the bright area of any glue from the tape, spray the
entire wheel with clear and cure, thats it no problems, it does not bleed
through, only precaution is making sure you properly cured the gold.  "FT"

 )