Re: buffing compounds

[TexasTR4@aol.com]

In a message dated 12/29/2000 1:30:50 PM Pacific Standard Time, 
flaedersaft@juno.com writes:

<< Ed,
 
 The compounds are applied to the spinning wheel by pressing the 
 hard stuff against the wheel. Not as easy as it sounds to get
 the right dose.
 
 Scott
  >>

Ed,

Check the compound to see if it is water soluble.  Some polishing compounds 
for jewelry work need to be dissolved in water and a loaded brush is applied 
to the spinning wheel.

RH...old rock polisher.....