i had the same problem on my tr6; the answer was sparying silicone on the
accelerator pedal bushings and linkage. it wasn't the carbs.
----- Original Message -----
From: <Herald948@aol.com>
To: <ollenz@yahoo.com>; <triumphs@autox.team.net>; <vtr@autox.team.net>
Sent: Wednesday, November 29, 2000 1:42 PM
Subject: Re: Stromberg problem [TR6]
>
> Please reply to <ollenz@yahoo.com> (Orlando llenza) if you can help!
>
> --Andy
>
> In a message dated 11/29/2000 1:22:29 PM Eastern Standard Time,
> ollenz@yahoo.com writes:
>
>
> > To: vtr-www@vtr.sanders.com
> >
> >
> > My tr6 is experincing the following: When the engine
> > is rev over 2000 and the gas pedal released the engine
> > remains at or higher rev for about 20-30 seconds the
> > begin to drop the the normal 900 rpm. They adjust
> > perfectly mixture wise and the diaphrams are almost
> > new. Could this be caused by worn out springs? The
> > choke is off, they are not dirty ect. Colud it be the
> > vacum advance?
|