In a message dated 10/2/00 7:02:07 AM Eastern Daylight Time, Gbouff1@aol.com
writes:
<< I have installed the boot lid on my TR3A and the edge of the lid that
folds
over hits the heads of the fender screws before it becomes fludh with the
body. I used washers between the screws and body. Can someone who has an
original car check to see if washers were originally used. Has anyone out
there eliminated the use of washers for the same reason? As always, thanks
for your responses.
Gary Bouffard 59 TR3A TS58399
Hi Gary
Not that either of my boot lids are anything like perfect, but I think you
perhaps need to lose the washers. There are not supposed to be any in this
application. Use loctite if you are concerned about them backing out, which
has never been a problem with any of mine.
Ken Nuelle
58 TR3A
62 TR3B
64 TR4
69 TR6
|