Per the Triumph Service Instruction Manual for TR2's & 3's, Section G "Front
Suspension and Steering", Page 6, Fig 3, the dimension is 7.68" and is
measured to the centerline of each ball joint body, or more specifically to
the centerline of the grease fitting on each ball joint body.
I know cause I've just assembled a pair with new joints.
Dave Brackin
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net]On Behalf Of James Fowler
Sent: Thursday, September 28, 2000 4:16 PM
To: triumphs@autox.team.net
Subject: Alignment TR3
In my repair manual there is a outer tie rod measurment. From what point to
what point should the meaurement be taken?
James Fowler
1960 TR3A
|