I'm installing a new wiring harness in my TR4.
I have an extra wire under the dash and I can't figure out where it
should go. Its a green wire with a black stripe.
There is a GB (green wire with black stripe) wire which comes out of the
wrapped bundle and goes to one spade connector on the temperature gage.
At this same spade connector a GB wire leaves and jumps over to the
spade connector on the fuel gage. A seperate GB wire leaves on a
different spade connector on the fuel gage.
So I have all those connected and still have ANOTHER green wire with a
black stripe with a spade connector with no home, no purpose in life,
destination unknown.
Can anybody help?
Will in Wisconsin
63 TR4
|