Hi All
It could have another purpose, it could be for alignment on a jig or fixture
during assembly, either sitting over a peg or having a bolt or stud and nut
for more rigid location. This is a guess from a toolmakers point of view, it
may be well off the mark as I don't know the exact location of the hole, I
am assuming that it is flat on the floor from the previous posts.
Graham.
2.5 PI MKII
Sprinted Dolomite
2000 MKI
Toledo
1300 Front Wheel Drive
http://www.triumph-iw.co.uk
> >
> > > I came across a round rubber plug (I guess) in the floor. About the
size of a half-dollar maybe. What's it for? Just curious.
> > > Jim
> > > CT54531L
> >
It is probably a drain plug, but
> whether the use was intended for production or later owner use, I'm not
> sure. It could be a joint purpose.
|