I wonder,
While putting back my canister and run-on valve back into my 73 TR6, I
noticed that my hose configuration was not the same as what is shown in
Bentleys. My return from the gas tank goes to the bottom ( run on
valve). I have 2 separate hoses 1 from each carb to the top of the
canister and one from the valve cover including 2 " T " fittings and
hoses from tops of carbs to the top middle nipple of the canister.
Question - is mine like this for a reason? Should I use the Bentley
configuration?
Thermostatic switch? I have this " T " fitting in my upper rad hose
without any of the vacuum connections in place. should I ?, what does it
do? my vacuum goes direct from the distributor to the carb.
TIA
Cliff
73 TR6
|