The one I bought simply required you to cut off the old end, insert the raw
cable in to the opening of the new end, and then it screwed down tight onto
it. Otherwise , you'll have to cut and solder it into place I guess, but
these kits are usually a ten minute job. I've put them on at swap meets.
> -----Original Message-----
> From: Jay Snavely [SMTP:jays@paonline.com]
> Sent: Sunday, March 26, 2000 3:04 PM
> To: Triumphs
> Subject: cut off switch
>
>
> I just bought a battery cut off switch from Moss. It attaches to the
> negative post and has a green knob. There is a hole thru the switch body
> at
> the end opposite the end that clamps to the battery post. Obviously the
> ground cable is to attach here, but I don't know how. The ground cable is
> permanently joined to the original clamp, there is no lug on the end for
> bolting, etc. TIA
>
> Jay
> 74TR6
>
>
|