> From: Jonathan Beaudoin [mailto:jbdoin@sympatico.ca]
> Sent: March 25, 2000 6:53 AM
>
> My TR is just back from his paint job... I now need to
> put the new bush on the sway bar. They are poly! Does
> somebody have a trick to slide them on the bar without
> breaking them?
I boiled mine in water for about 5 min each and they slid on without any
cutting required. Make sure the sway bar is clean and smooth and you should
have no problem (assuming it's the stock sway bar, can't say for sure about
after-market bars). Also, wear gloves when you are handling the hot
bushings, they do get hot in the water.
Good luck!
Peter Zaborski CF58310UO
|