In a message dated 13-Mar-00 14:17:49 Eastern Standard Time,
STaffel@bcps.k12.md.us writes:
> ARTHUR -BOTTOM LINE is your measurements are absolutely the correct ones
> (you know this-some top makers don't!)
> Perhaps a note on the VTR Top installation page "BEFORE YOU Make ANY Lift
> the Dot Installations or other snap attachments-carefully check the seams
of
> your top with the hoodstick in the upright position-
> The top fits snug-but no doubt the 'stress factor over time will shorten
the
> life of the top by 25-30%
>
Sherman, thanks for your feedback. MY Robbins top instructions said that the
return clause was voided if any snaps had been installed. fo that reason I
was very careful at the "top shop" where I took the top to be installed I
told the guy to trial fit the top first and then install the snaps. I also
supervised the job. That is what we did and there was no problem.
Sorry if I didn't tell you that -- you only asked me for the dimensions and I
assumed that you would know about the snaps from the guarantee. I hope this
works out for you.
Art Kelly
|