Ken, I looked it up on ListQuest and found the following...
http://www.listquest.com/lq/view.cgi?ln=triumphs&sp=11&q=D%2dholes&b=1&o=0&x
=23&y=11&ci=c004421565&mid=68216
If that doesn't get you there, I searched for D-holes
Overall, the opinions seemed to be that you're better off drilling small and
filing to fit although I did see a link to Greenlee tools. Anyway, several
replies to the original question at the bottom of the above link.
Personally, I prefer Ken Nuelle's suggestion! (Take a regular drill bit and
file it flat on one side!) :^)
Michael Ferguson
----------
>From: "Ken Gano" <triumphs@mcleodusa.net>
>To: <triumphs@autox.team.net>
>Subject: D holes
>Date: Sat, Mar 11, 2000, 7:31 PM
>
>
> I know this has been discussed before, but I can't find the references now
> :). Does anyone know a source for punches to make the d shaped holes as use
> on our dashes? I checked the check the usual sources (McMaster-Carr, MSC,
> etc.) to no avail.
>
> TIA
>
> Ken Gano
>
>
|