i emailed an info request and was given the sb3824 number as a
proper fit for my 76 TR6 as well. i ordered 4 plus 1 for the slave
cylinder. total will be about $35 bucks. pretty cool stuff if they work
as advertised.
Tom Di Iulio
1976 TR6 (w/ new anti run-on valve)
Denver, Co
----- Original Message -----
From: "Evans, Mark" <Mark.Evans@Anheuser-Busch.com>
To: <ebk@buffnet.net>; <triumphs@autox.team.net>
Sent: Wednesday, February 23, 2000 2:59 PM
Subject: RE: Speed Bleeders for TR4A
>
> FYI
> Speed Bleeder did respond to my e-mail requesting size info for the TR4A.
The
> size is 3/8 x 24 TPI. All five bleed nipples on the TR4A are this size.
Their
> part number is SB3824. The current cost each is $6.50 each with a charge
of
> $3.00 shipping. I only ordered one for the clutch slave cylinder but I
believe
> the shipping charge is a flat rate that will cover more than any car
needs.
>
> Thanks to all who responded.
>
> Mark A. Evans
> 1966 TR4A IRS CTC63970 LO
>
> P.S. If one got their "t*ts in a mangle", could they use a Speed Bleeder
to
> replace some of the parts?
>
|