Hi John
Is this a column mounted steering lock come ign switch? If so read on. It
sounds like the switch, try letting it back gently after it fires rather
than letting the spring take it. the bit at fault will probably be the
wiring side of the switch rather than the mechanical. That is the
(generally) white plastic bit on the end of the switch with the wires
affixed held in by two small cross head screws. you will almost certainly
need the specific part rather than a generic ign switch.
Graham.
----- Original Message -----
From: John Summers <trumpet@bellsouth.net>
To: <triumphs@autox.team.net>
Sent: Monday, February 21, 2000 8:38 PM
Subject: Ignition switch
>
> Dear folks, I went out to my '74 TR 6 today for my daily errands and
> when I turned the ignition key notices a milisecond of hesitation before
> the car fired. Noting that I had noticed this I shut it off and tried
> again just for fun. This time the milisecond turned into several
> minutes of turning the key with no response. I was getting power
> through the switch because the guages would register and the radio would
> play. After checking wll of the known (to me) connections under the
> hood I gave it another shot. Nothing. So I sat there and fiddled with
> the key, turning it off and on for 10 or 15 tries. The beast would
> start randomly and run normally.
> So I drove to the most important destination and left it running while I
> went inside. Got home ok and shut it off and of course it wouldn't
> start.
> Does this sound like the problem is in the switch to you?
> If so will it require a new switch or can I take this one out and play
> with it,,,,no, I'd get a new one. In this case, are all ignition
> switches alike? I.E., can I get a General Motors or Toyota "switch" or
> do I shwll out the $$ for one from our normal catalog suppliers??
> This is my "only" driver so I need it's full cooperation.
> Thanks folks,
> John Summers
> Jacksonville, FL
|