BINGO
Thanks Andy, that's where I read about spedi sleeves. It wasn't a
website after all (told you my brain was feeble). It IS in the Six Tech
by Len Renkenberger. Just went and found my Six Tech and looked it up
(page E-6 for those of you with a Six Tech). He talks about using the
spedi sleeves on front spindles, axle shafts, and engine timing gear
covers (which is my potential use for the spedi sleeve and why I was
looking for the info.). Some other areas where they can be used are the
upper inner fulcrum, lower inner control arm hole and outer lower
control arm hole.
I'm glad I didn't have to look through all my bookmarks and all my
manuals...drives me nuts when I know something I'm looking for is there
but I can't find it. Andy, you saved me a lot of anguished looking.
Thanks.
Bud Rolofson
Andy Dixon wrote:
>
> Bud,
> Len Renkenberger, former tech editor of 6 pack, has a collection of articles
> called 6-Tech (what else), some of these articles go into some detail on
> spedi sleeves, He swears by them.
> Andy
>
> -----Original Message-----
> From: owner-triumphs@autox.team.net
> [mailto:owner-triumphs@autox.team.net]On Behalf Of levilevi@home.com
> Sent: Saturday, February 12, 2000 10:28 PM
> To: Triumph List
> Subject: Spedi Sleeve
>
> List,
>
> Has anyone else seen a tech article about using a spedi sleeve (aka a
> stainless steel sleeve that comes in various thicknesses). I know I saw
> an article about it somewhere on a website but can't find it or remember
> exactly where. My feeble little mind seems to think it talks about
> replacing seals AND the use of a spedi sleeve to "line" a grooved or
> worn shaft. I found a local supplier of the spedi sleeve (and yes
> that's how it's spelled in the literature) here in Denver and now I want
> to reread the article but of course can find it in my own archives or on
> a website reference on listquest.com
>
> Has anyone else seen such a reference and/or can steer me to where it
> is?
>
> Thanks in advance.
> Bud
|