Irv-
I just installed a new wiring harness in my TR4 yesterday- , My Wood
dash is not on yet, but the metal unit is complete, along with all dash
crash padding top & bottom. In order to feed the harness to instruments,
steering column, dimmer and wiper motor-you have to deed the harness in
stages and carefully BEHIND THE HEATER MOTOR- in order to do this I
removed only the glove box, then you can work both through and below the
'glover box area. -Not a hard job just work thoughtfully.After feeding
the harness through the firewall the engine bay install the grommet
from the front of the harness,working backward along the harness to the
place it goes, and then 'pop it in. Use of needle nose pliers to spread
the grommet opening helps a whole lot in feeding through the individual
wires and connectors. HAve fun!
|