In a message dated 1/10/00 1:33:23 PM Eastern Standard Time,
randallyoung@earthlink.net writes:
<< Two tricks that help :
1) After putting the upper bolt in place, snug up the lower bolt, so it
holds the starter in position.
2) Use duct tape to fasten the upper nut to a long, flat box-end wrench
(ring spanner ?)
Randall
59 TR3A TS39781LO >>
I have the top bolt oriented so the nut is on the engine side. When you pull
the starter
you just leave the bolt in place. Much easier to get the nut on from this
side as well, no duct tape required. When you first place the starter you can
kind of hang it on this bolt too.
Bit tricky tho' as it is very easy to knock the bolt out of place, and it
requires strong fingers to get it into place with the trans tunnel on.
Ken Nuelle
58 TR3A
62 TR3B
64 TR4
|