Steve
First make sure that its not the end of the screw being too wide to
come out. You have probably noticed that the end is split and widened so the
screw will not back out when the carb is assembled and in operation. I can't
imagine the screw being that tough to remove. I just did 3 strombergs with no
problem. I vote for grinding the end flat and if it still won't move, drill it
If i remember correctly only one revolution. hope this helps.
Ken
Ken Copeland
70 GT6+ KC78784
70 Spit FDU84919
70 GT6+ KC81551 (Ok so I like 70s)
|