McMaster-Carr carries a full range of Clover grinding compounds, in both
grease based and water based formulas. The catalog provides a little
guidance on which one to select. Lapping is a nice finishing touch, but
should not be expected to take the place of a seat and valve face
resurfacing job. see page 2014 or 2015 of catalog #100, or the website at
McMaster.com, under lapping compound. Leave the lard in the kitchen.
Bob Westerdale
----Original Message-----
From: Michael D. Porter [mailto:mporter@zianet.com]
Sent: Wednesday, October 20, 1999 11:39 PM
To: George Richardson
Cc: Triumph List
Subject: Re: valve grinding compound
George Richardson wrote:
>
> Anyone know where you can get valve grinding (or lapping) compound?
> Would a local auto parts store have it?
Most auto parts stores should have it. The most commonly available is
made by Permatex. Some older parts stores may still carry a brand called
Clover, which was extensively used in earlier days. The Permatex, if
memory serves, has a bit coarser abrasive, and cuts faster. Clover, I
think, has a less aggressive abrasive, so it's less likely to cause
trouble if one gets overly ambitious.
Cheers.
|