> How do I get the filler off and get to the screws? I'm afraid to go
> wild with my old putty knife and hammer, since I'm sure the underlying
> metal is fairly weak. My drill and wire wheel had no effect. Is there
> a chemical solution?
When I was faced with removing large patches of bondo, I found that a putty
knife and a propane torch worked pretty well... Heat the filler, it should
soften, and be easier to remove.
Don't let it burn, stinks bad. 8-)
Phil Pattengale
54 TR2 - TS1440-LO {project #1}
56 TR3 - TS13872-L {project #2}
philpatt@kalamazoo.net
http://www.geocities.com/MotorCity/Track/2890/
|