Folks, I received the following and cannot give a definitive answer for the
TR6. Anyone help this person out? Thanks. Cheers.
Art Kelly
FORWARDED MESSAGE ---
I read your article on "Refinishing Triumph Wood Fascia Panels". It looks
like you went through a lot of hard work. I own a TR6, and the dash could
use a little TLC. The veneer is starting to chip in a corner, and its time
for a little face lift..
Did you have difficulty removing the fascia panel? I attempted to do so, and
the panel is easily pulling away from the glove-box side, however, I cannot
seem to get it loose from the driver side. I tried looking at the manuals,
but it is not very specific as to this task.
Can you share any thoughts on how to make this whole task easier?
Thank you very much for your input. I can be e-mailed at ANI63@AOL.COM
END FWDED MESSAGE
|