In a message dated 5/5/99 2:59:37 AM Eastern Daylight Time, amdixon@erols.com
writes:
<< Any thoughts on how to lean out the mixture on a 59 TR3 with the H6 SU's?
I've tried the LM needles and it didn't seem to make any difference.
They were rich so I rebuilt them (not the shafts - leakage there should lean
them out?) to no avail.
Engine was rebuilt about 50 miles ago then sat for a couple of years -
started occasionally. Engine fires right up. Why not? It runs like the
choke's
on. Runs strong.
Any hints on what to look for?
TIA
Andy D. >>
Maybe too obvious, but I didn't see it in the original post. Have you tried
adjusting the mixture screw/nut on the bottom of the carbs? Beyond that I'd
look at the float bowl adjustment.
Ken Nuelle
58 TR3A
62 TR3B
64 TR4
|