Brad,
The yokes on the driveshaft are supposed to be _parallel_ with each other.
This is true of most cars except, I think, the trans am?
It is easy to dial-in the setting.
On my car, there was a vibration from an unbalanced/bent shaft
that somebody tried to dial-out the vibration by mis-phasing the
yokes. The idea was to create an opposite vibration to cancel out
the problem. Didn't seem to work too well. Had demolished a U-joint
when I got it.
-Tony
Message text written by INTERNET:triumphs-owner@autox.team.net
>From: "Brad Kahler" <brad.kahler@141.com>
Subject: "phasing" a drive shaft
Listers, I can't find any of the references that I thought I had saved on had
to "phase" a drive shaft. Can anyone inform me (again!) how this is done?
TIA
<
|