In a message dated 4/6/99 9:20:50 PM Central Daylight Time, hsgentry@cfw.com
writes:
<< I have not done this job, but am geting ready to do it. Your instructions
make sense except for one part... I don't see how you can remove the
rotoflex donut without pulling the shaft out of the hub. It will not go
over the three prongs of the outer shaft. I have practiced this with a
spare vertical link and I can see no way to do it. I am almost certain
that the the Bentley manual says to pull the hub.
I will look again, it has been a while. If you know a trick to get the
donut off and another one on I would like to know it.
Thanks, Sam
>>
Thanks, Sam. You're absolutely right; you do have to pull the hub. I guess
it's been longer than I thought since I did this!
Frank M.
|