>From: "Brad Kahler" <brad.kahler@141.com>
>Reply-To: "Brad Kahler" <brad.kahler@141.com>
>To: triumphs@autox.team.net
>Subject: TR4 - removing rear axle seals???
>Date: Sat, 20 Mar 1999 11:29:16 -0600
>
>Listers,
>
>Is there any recommended method for removing the rear axle seals from
the
>ends of the diff housing? The pinion seal wasn't to bad because it is
flush
>with the housing, but the axle seals are recessed several inches.
>
>How about it, any good suggestions out there?!!
>
Yea, but it aint pretty... I cobbled somethinf together many
years back using a slide hammmer fender tool, and a stovebolt
thingie... pulling the seals took entirely too long, was
frustrating in the extreme... All the while I was cursing and
swearing, whishing someone would come up with a simple device
that would allow one to get behind the seasl and pull it out.
Of course after I got the seal replaced I for gor promptly
about having something made.
Greg Petrolati
Greg Petrolati Champaign, Illinois
1962 TR4 (CT4852L)
That's not a leak... My car's just marking its territory...
|