In a message dated 99-03-18 14:00:35 EST, you write:
<< So here's the question: once this rubber is installed, should it be
kind of wavy, to accomodate the bend it will undergo when placed
against the body? Or, have I stretched it too much? Or, will it
tighten back up in a few days?
Any useful insight appreciated.
Thanks,
Jim Wallace
60 TR3a >>
The bottom rubber blade shouldn't be wavy, or at least none I've done were.
Make sure you have the orientation right. The word "front" or "back" is often
cast into the rubber mould. It won't seal right if it's backwards. If it is on
correctly then about all you can do is try it and perhaps it will sort itself
out on the car. If you get it all together and find then that you have to
start over, THEN it's a windsceam!
Ken Nuelle
58 TR3A
62 TR3B
64 TR4
|