Well, I got my rear hubs back from the guy in Denver. I took one apart last
night, and need some help:
1) it doesn't look like there are any seals in this hub I took apart. I put
a rear seal in that I had bought from a local auto store, but I'm not sure
that this is how it is supposed to sit. There wasn't a rear seal in there to
go by.
2) I can't figure out how to get the front bearing off. It spins okay, but
won't come off of flange like the rear bearing did. If I can't get it off, I
can't put a seal in there (although again, it doesn't appear to have a
seal).
Anyone out there understand how these go back together? I can always muddle
my way, but I don't want to ruin a perfectly good bearing (and won't, since
I refuse to pry it off. There must be some trick to get it to "pop" off).
Thanks.
Bryan Stinocher
bdstinocher@sewsus.com
502-782-7397 xt 2284
1968 TR250 CD 5853 L
|