The bolt that holds the lower wish bone to the vertical link is frozen
solid both sidesof car. Pressing out with a hydraulic press only bent the
½" steel spacer plate on the press. I cut the bolt on each side of the link
and found it to be threaded the total length. Well I surmise so because the
short ends sticking out of the vertical link are threaded on both ends.
Now for the question to decide if I have major problems.
Is it just a slide fitting through the vertical link???
If so I plan to drill out the rest of the bolt. If not I plan on
crying a lot......
The arthur
kit car aka 69 GT6 (problems problems)
garage ornament aka 82 Jag
boxy thing on wheels aka ford aerostar
|