Re: TR6 - Throwout Bearing Holder

[Aaron Johnson <sugar@holly.ColoState.EDU>]

I would assume that this pin isn't needed because it is the same holder
that the 4 uses but the 4 doesn't use the pin.  The only reason I can
think that the pin was installed was to make sure the bearing spins and
not the sleeve.

aaron

On Wed, 16 Dec 1998, Martin Gonzales wrote:

> 
> Do you really need the pin that is installed on the throwout bearing holder?
> It is suppose to be there to prevent the bearing and holder from turning 360
> degrees.  Why should that be prevented?
> 
> Martin
> 73 TR6
> San Jose, CA
> 
>