In a message dated 98-10-29 00:03:07 EST, you write:
<< The left most tenax stud for the convertable top is long missing and the
hole in the windshield frame that it came out of is much too oversized for
a new one, at least any I've been able to find.
Has anyone run into this situation and found a cure? I thought about
drilling straight through both sides of the frame, but that seems a little
drastic. Any thoughts would be appreciated.
Bob
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Oooo!
Nasty one Bob!
All I can think of is to get another frame - shouldn't be too hard to find.
I think if you drill through you're gonna hit glass!
Other than that epoxy might hold it for a while, or you could probably take
the frame apart, braze and redrill the hole, grind , polish and rechrome!
Ken Nuelle
58 TR3A
62 TR3B
64 TR4
|